The D-110 is
a linear 2-channel power amplifier of extremely high quality construction
designed for the reproduction of speech and music. It represents "second
Generation" advancement of Audio Research's analog module technology.
With the
D-350 and D-100A technology to draw from, the D-110 was conceived to embody
those parts of each design that could be brought together to provide an
amplifier having the very highest possible performance level within its power
capability.
Assuming a
basically linear and stable amplifier design with adequate "slewing
rate" to allow possible audio waveforms to be reproduced with low
distortion, there are still two most important factors that must be dealt with
if it is to be capable of driving loudspeaker loads "fast and clean".
One is the "stiffness" or "muscle" of the output-driver
stage; the other, a stable high capacity power
supply, capable of providing the instentaneous current demands of the
circuit. By utilizing the D-350 power supply, with its 300 joule energy
storage, and the D-100A output stage rebiased to a much higher "idle"
current (the 3 built-in, superquiet fans keep the ambient temperature to a very
reasonable level), an amplifier has been created that provides a new level of
music reproduction. To obtain the performance this amplifier is capable of, it
is recommended that only commensurate quality preamplifier-control units (such
as the SP-3B, SP-5, SP-6) be used with it. Also, only high quality turntables
with stable arms and cartridges should be used.
Features:
All solid
state featuring Audio Research's analog module technology and unique linear
output circuitry.
Power-line
monitor meter with operating ranges identified.
Output power
monitor meters - peak "averaging" circuitry to monitor safe operating
(sine wave power calibration 100 watts/8 ohms top of green arc).
Built-in
speaker line fuse holders - user can assure absolute speaker protection.
Front panel
power supply fuses for easy acces
Super-quiet
built-in fans to assure reliable operation
Front and
rear panels are 2-color anodized aluminum for permanent finish and lettering
Industrial
grade components and construction for long service life. Rated for continuous
commercial service.
Specifications
Power
Output: 100 watts per channel minimum
RMS (both channels operating) at 8 ohms from 1 Hz to 20 kHz with less than ,25%
T.H.D.
Intermodulation
Distortion: less than 0,05% at rated
output (80 Vp-p) and load (SMPTE method)
Total
Harmonic Distortion and Intermodulation Distortion both decrease with
decreasing output (typically less than 0,02% at 1 watt per channel RMS)
Power
increases to maximum at 4 ohms
Input
Sensitivty: 1,5 volts RMS for rated
power and load
Input
Impedance: 30 k Ω (nominal)
Damping
Factor: more than 200 at rated power and
load (20 Hz to 20 kHz)
Noise: wide band, unweighted, more than 100 dB below
100 watts at 8 Ω - power line components (hum) 90 dB below 100 watts at 8 Ω
Power Requirements: 105 - 125 / 210 - 240 V
AC, 50/60 Hz
Power
Consumption: 600 watts maximum
Dimensions
(W x H x D): 480 x 265 x 436 mm
(19" x 10-1/2' x 17-1/4")
Handles Extend: 41 mm (1-5/8 ") forward of
the front panel
Weight: 42 kg (92 lbs) Net
Nessun commento:
Posta un commento